Heat Fab, now a division of Selkirk, is a producer of high quality flue venting systems. Their products are the standard for condensing boiler and water heater systems.

Contact your Associated Equipment Sales representative about any of the fine Heat Fab products below:

Saf-T Vent CI Plus

Saf-T Vent CI Plus is the leading commercial double-wall special gas vent system made from superferritic stainless steel. With increased airspace between the inner flue conduit and the outer jacket, today's CI Plus reduces the required clearance to combustibles and makes a more rigid flue pipe - large diameters are easier to handle.

Saf-T Vent SC

The Saf-T Vent® SC is a concentric vent system designed for zero clearance installation in residential and light commercial applications. It is approved for use on ANSI category I, II, III, and IV Gas-burning appliances, and direct vent or sealed combustion appliances approved by the appliance manufacturer.

Saf-T Vent EZ Seal

Now, the strongest special gas vent is also the easiest to install. With new integral seal, and patented Ring and Tab™ closure system, Saf-T Vent EZ Seal is the fastest and most reliable venting solution for Category I, II, III and IV gas appliances –– with no RTV sealant required. Look inside. The red seal is your guarantee of Saf-T Vent quality –– and performance you can depend upon.

Saf-T Vent GC

Saf-T Vent GC is a single-wall venting system fabricated from AL 29-4C ® stainless steel. Designed for multiple applications, Saf-T Vent GC can be installed for use as Saf-T Vent Special Gas Vent, Saf-T Vent Gas Vent Connector, and Saf-T Vent Masonry Chimney Liner.

Click here to enter Heat Fab’s website